1950 AD Truck Cab Mount Floor Hole Locations - The 1947 - Present Chevrolet & GMC Truck Message Board Network

patrickk1 · 01-25-2010, 03:52 PM

What are the measurements between the holes (center to center) for the holes in the floor for the cab mounts? I am replacing the cab mounts and the floor was previously replaced and i think the holes drilled in the floor might be off. The old mounts were rusted out in the area where the old mounts sat so i can not use them as a reference. My back two mounts/floor area is perfect. I was looking for the dimensions from hole to hole for the front to front, front to back on both, and diagonally from back left to front right and so on.

Thanks.

01-25-2010, 03:52 PM	#1
patrickk1 Registered User Join Date: Apr 2009 Location: Billerica, Ma Posts: 197	1950 AD Truck Cab Mount Floor Hole Locations What are the measurements between the holes (center to center) for the holes in the floor for the cab mounts? I am replacing the cab mounts and the floor was previously replaced and i think the holes drilled in the floor might be off. The old mounts were rusted out in the area where the old mounts sat so i can not use them as a reference. My back two mounts/floor area is perfect. I was looking for the dimensions from hole to hole for the front to front, front to back on both, and diagonally from back left to front right and so on. Thanks. __________________ - Patrick 1964 GMC pickup lwb ~ My newest build! 1937 Ford Coupe ~ Custom frame, LS1, quickchange 1950 Chevrolet 3100 ~ Bagged (Sold) 1931 Chrysler Roadster ~'32 Ford Frame, Channeled 8" (Originally a 60's show car) 1967 Chevelle ~ 454 Triple Black (Sold) 1964 Chevrolet Impala SS (Sold)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.