Holley 4160: How the HECK to do I get the Fast Idle Cam Screw?!?! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

TIMSPEED · 05-04-2003, 06:54 PM

Seriously, it's IMPOSSIBLE to get to with the carb on. Is there any way I can simply turn it easier? I found out last night, that the fast idle cam is what's been buggin my truck! I pulled up the arm, to set the fast idle cam to 1400rpm, and I let the truck warm up for 5 minutes (hadn't been started all day) and I came back out. On the way to my friends house, the damn thing ran like a CHAMP!! So, I just gotta adjust that stupid little screw and I'm home free! Just gotta figure out what to use to do it! Any ideas?

05-04-2003, 06:54 PM	#1
TIMSPEED Join Date: Jan 2003 Location: Modesto, CA Posts: 1,321	Holley 4160: How the HECK to do I get the Fast Idle Cam Screw?!?! Seriously, it's IMPOSSIBLE to get to with the carb on. Is there any way I can simply turn it easier? I found out last night, that the fast idle cam is what's been buggin my truck! I pulled up the arm, to set the fast idle cam to 1400rpm, and I let the truck warm up for 5 minutes (hadn't been started all day) and I came back out. On the way to my friends house, the damn thing ran like a CHAMP!! So, I just gotta adjust that stupid little screw and I'm home free! Just gotta figure out what to use to do it! Any ideas? __________________ I have a few cars... See Them Here

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.