85 K10 project - The 1947 - Present Chevrolet & GMC Truck Message Board Network

DirtRider1357 · 02-16-2010, 06:15 PM

Its an 86 k10 was auto but guy before me changed it to manual. He told me the only thing that needed to be done was that the clutch needed to be bled. We did that and drove it around the block and it shifted fine. We went to drive it again except this time when i went to downshift it would not go back into to gear.

Does anyone know what might be the problem. One person told me it might be stuck between 4wd and 2wd but we checked that and its not stuck between.

Any ideas on what might be the problem would be great. Thanks.

02-16-2010, 06:15 PM	#1
DirtRider1357 Registered User Join Date: Feb 2010 Location: Morrisville, PA Posts: 54	86 K10 project Its an 86 k10 was auto but guy before me changed it to manual. He told me the only thing that needed to be done was that the clutch needed to be bled. We did that and drove it around the block and it shifted fine. We went to drive it again except this time when i went to downshift it would not go back into to gear. Does anyone know what might be the problem. One person told me it might be stuck between 4wd and 2wd but we checked that and its not stuck between. Any ideas on what might be the problem would be great. Thanks. Last edited by DirtRider1357; 02-16-2010 at 06:33 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.