|
04-02-2010, 10:07 PM
|
#1 |
|
Formerly- 1972SuperCheyenne
 
Join Date: Oct 2008
Location: Wake Forest NC
Posts: 5,782
|
LS swap harness
This harness is for a 6.0/4l80e. I have decided to go with a full custom harness for my 6.0 swap because I just cant seem to make this one route and hide like I want it to. This harness will work fine if you are wanting to mount it like the factory did. It will look like the harness on Glocks truck. I lengthened the wires for the ect sensor, IAC sensor, TPS sensor and alternator in an attempt to make it look like I want it to. They will work fine still because they run under the fuel rail on the drivers side and when the intake cover is on you cant see them anyway. I am going to start at $200 SHIPPED. This is already set up for standalone operation by wait4me so there is minimal wires to hook up to make it run. I will label all connectors for you so you know where they go too.
__________________
--Josh My Build Thread:http://67-72chevytrucks.com/vboard/s...d.php?t=799218 A good crossthread is better than Loctite any day. Life is not about what you have, but who you have to share it with. Last edited by STOCKISH; 04-02-2010 at 10:09 PM. Reason: At 31 years old I still cant spell. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode