|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-15-2010, 02:38 AM
|
#1 |
|
Chevy Lover Till The End.
Join Date: Dec 2009
Location: Mascot TN.
Posts: 795
|
Upper Ball Joint Trouble
Hello, I replaced my upper control arm shaft and bushings on my '69 C10 and new upper ball joint and new rubber bumper. The trouble is I can't get the new upper ball joint in the spindle enough to start my nut. I have tried a C-clamp and hammer and I can get it almost enough to feel a thread but I can't get it to go any further to get the nut on to tighten it up. I checked the ball joint to the old one and it's the same. Anyone got a trick to getting it in enough to get my nut on? Thank you
__________________
1969 Chevy SWB Big Block - Under the knife as of 12/26/2011 1989 Chevy Silverado, 4X4 - Daily Driver 1996 Chevy Suburban K1500 - 4-Wheeler, Campin Truck 1968 Chevrolet Impala Sport Coupe - 327/350hp, TH400, all original. Members I've met: BamaBaxter, My Build: http://67-72chevytrucks.com/vboard/s...d.php?t=500359 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode