How about this setup? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**kev2809** · 08-03-2010, 10:36 PM

ive decided to rework my suspension a little bit, to get a few inches lower. it probably wont be until fall or winter until i get around to doing it but i want to get the parts and thinking out of the way now lol

i would like to do a setup like this...except instead of using a bridge bar on top to mount the bags, i would like to weld a top plate on top of the frame, then still offset a circle plate on the trailing arm like the pic below. this way, the ta will hit the frame, and i can get another 3" lower (the size of the collapsed bag). would this work?

08-03-2010, 10:36 PM	#1
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,184	How about this setup? ive decided to rework my suspension a little bit, to get a few inches lower. it probably wont be until fall or winter until i get around to doing it but i want to get the parts and thinking out of the way now lol i would like to do a setup like this...except instead of using a bridge bar on top to mount the bags, i would like to weld a top plate on top of the frame, then still offset a circle plate on the trailing arm like the pic below. this way, the ta will hit the frame, and i can get another 3" lower (the size of the collapsed bag). would this work? __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.