the truck is home sitting in carport.has no engine so i cleaned out the engine bay.awaiting to paint.i picked up a used 350 4 bolt main that had previously been rebuilt.
casting number 10066036 hencho en mexico,under the one head id # m112191p.anyone know what year it is ? getting too much general info 1968 to 1988 ......
not to trust what a person says i ordered new gasket kit ,edelbrock valve covers.was a great deal.and in the process of looking for a edelbrock intake and a 600 cfm carb with manual choke.this is my want list.
took off the carb and intake uh oh water..... took off the heads there was a little water sitting on two lifters.could i just soak these in oil or should i replace.and water sitting in one of the cylinder.i will soak it in wd-40 and will try to free it.and wet sand 600 grt paper on the cylinder wall.hopefully this does the trick.other than that all the cylinder look good no ridges.just hoping there will be any pitting on the one cylinder wall.any input guys give me ideas as i"m pretty new at this.and haven"t done this to a engine in 20 years.i"m in the th low to no buck club.but will have a nice ride in the end.
09-12-2010, 12:03 PM
Threaded Mode