|
06-17-2003, 11:17 PM
|
#1 |
|
Longtime Member
Join Date: Oct 2002
Location: Over Yonder (DFW)
Posts: 171
|
SWB Frame
There is a possibility that I might acquire a '68 SWB in the near future for next to nothing. The body is in really rough shape, so I'm mostly interested in the truck for the frame. I figure I could strip it bare and rebuild it with all new components the way I want. This will allow me to work on it as time and money are available and most importantly, let me continue driving my '69 LWB until the SWB frame is done. The question I have is this: After I strip the frame down to nothing (framerails and crossmembers) and set it on jackstands, how will I make adjustments if it isn't square? I know how to measure for squareness. But since I don't have access (or the money) to a frame table, can any of you suggest an "in-the-garage" solution?
__________________
Rokcrln - "I'm a major car addict so trying to go as low buck as possible is like asking a coke head to use flower to save money." 1972 C10 Short Step -http://67-72chevytrucks.com/vboard/s...d.php?t=261405 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode