PCM programming in Phoenix, AZ - The 1947 - Present Chevrolet & GMC Truck Message Board Network

azsmokey · 02-13-2011, 01:37 PM

Can anyone recommend a reputable shop/person that can assist us with reprogramming our PCM?

We have a 72 K-10 with a Vortech SC'd 6.0/4L65E/NP205 combo. We used the Painless 60221 powertrain harness. Painless states that the PCM needs reprogramming prior to successful startup. At this point the engine cranks and all systems appear nominal, however it will not run. Unless I missed something, which is quite possible, I probably should have the PCM done.

Any ideas, comments, suggestions?

Thanks

02-13-2011, 01:37 PM	#1
azsmokey Registered User Join Date: Dec 2007 Location: Glendale, AZ Posts: 156	PCM programming in Phoenix, AZ Can anyone recommend a reputable shop/person that can assist us with reprogramming our PCM? We have a 72 K-10 with a Vortech SC'd 6.0/4L65E/NP205 combo. We used the Painless 60221 powertrain harness. Painless states that the PCM needs reprogramming prior to successful startup. At this point the engine cranks and all systems appear nominal, however it will not run. Unless I missed something, which is quite possible, I probably should have the PCM done. Any ideas, comments, suggestions? Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.