Round peg in a square hole - The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network

Click Here



Register or Log In To remove these advertisements.

		The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps
Round peg in a square hole

Site Merchandise

Mark Forums Read

Prev

Previous Post

Next Post

Next

03-06-2011, 12:56 AM	#1
shrunken66stroker Registered User Join Date: Jan 2008 Location: Las Vegas, Nv Posts: 954	Round peg in a square hole I just got my cam and I was running through some pre-assembly steps before I build my LS2. When I went to put the timing sprocket on the cam it wouldn't fit. The dowel is round and the hole(for lack of better terms) is oblong. The cam is for an LS2 and the timing set is for an LS2, so wth? Anyone know why this would be the case? Do I drill it out or buy another timing set? Attached Images __________________ http://67-72chevytrucks.com/vboard/s...54#post3194654 Last edited by shrunken66stroker; 03-06-2011 at 12:57 AM.

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 12:47 AM.