Th350 tranny kickdown cable - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JORGIE95961 · 04-12-2011, 09:56 AM

Ok so im almost done iwth my manual to auto swap.. but im stuck here.. my kickdown is about two inches short...???? i also swapped out motor intake and car from a dinky two barel to the 4bbl.. i used the bracket that was on the 2bbl intake whick i thought was the same on them all..... actually my throttle likake wont fit on its bracket either... on the thgrottle the origional truck with this engine . never had a throttle bracket... any ideas on thios stuff? do i just make an extention..?

04-12-2011, 09:56 AM	#1
JORGIE95961 Registered User Join Date: Feb 2011 Location: OLIVEHURST CA Posts: 570	Th350 tranny kickdown cable Ok so im almost done iwth my manual to auto swap.. but im stuck here.. my kickdown is about two inches short...???? i also swapped out motor intake and car from a dinky two barel to the 4bbl.. i used the bracket that was on the 2bbl intake whick i thought was the same on them all..... actually my throttle likake wont fit on its bracket either... on the thgrottle the origional truck with this engine . never had a throttle bracket... any ideas on thios stuff? do i just make an extention..?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.