![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Just a car guy
Join Date: Feb 2006
Location: New Washington, IN
Posts: 991
|
Brake pedal not touching stop after master cyl swap
I've been working on a ton of stuff including swaping to disc brakes.
Truck is a 1969, had manual drum brakes. I purchesed a new master cyl for a 1975 truck with manual disc brake. After bench bleeding I installed it. Used pushrod that came with new one and hooked it up to the brake pedal. I had to push the pedal about 1" to get the pushrod to reach. This of course makes the brake lights stay on. I can probably adjust the switch, but I wanted to know if this is ok? The pedal sirs lower than the clutch now, it is almost flush with the has pedal. Should I use the 69 pushrod? I think it got tossed but it seemed like it was quite a bit different than the one that came with the 75 Posted via Mobile Device
__________________
1955 belair Blown Pro Street cruiser 1971 Camaro Pro Touring 1973 Vega Drag Car 1970 C20 tow rig Last edited by OJ1988; 04-23-2011 at 10:34 PM. |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|