Lt1 Slave/ Master help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Wvgearhead · 05-29-2011, 11:05 AM

I have a t56 (LT1) that I am going to run in my 53, and I am trying to figure out what pedal and master combination I am going to use. I am thinking about using circle track set up from howe or wilwood. I think the master comes with the 4an fitting. Will this work with the stock gm slave(I do not have yet). Also what size master should I get? 3/4" 1"? My neighbor runs circle track and thinks this would be a good street setup too as far as the brakes(non power) go. Has anybody used a similar setup?

05-29-2011, 11:05 AM	#1
Wvgearhead Registered User Join Date: Jun 2010 Location: Charleston Wv Posts: 159	Lt1 Slave/ Master help I have a t56 (LT1) that I am going to run in my 53, and I am trying to figure out what pedal and master combination I am going to use. I am thinking about using circle track set up from howe or wilwood. I think the master comes with the 4an fitting. Will this work with the stock gm slave(I do not have yet). Also what size master should I get? 3/4" 1"? My neighbor runs circle track and thinks this would be a good street setup too as far as the brakes(non power) go. Has anybody used a similar setup?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.