|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-10-2011, 01:55 AM
|
#1 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Exhaust vs brake-lines
I'm starting to determine the routing for the 2.5" exhaust on my 'Recycle' project.
As I was trying to visualize where things were going to go, I noticed that it's pretty cramped where the pipe has to drop down under the manifold on the pass side. There's enough room for the pipe between the starter & frame but I noticed it's going to wind up fairly close (approx 1") to the rear brake-line. How close is too close??
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. Last edited by SCOTI; 06-10-2011 at 01:55 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode