Introduction and Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

beaterC10 · 07-31-2003, 01:36 PM

I'm new to the board, joined last week. Thought I should introduce myself. My name is Dave Reasoner. I have a 84 short stepside beater that gets my attention when I have spare time. You guys with kids probably understand 3 kids and a wife take a lot of my time.

My question concerns the New Process 833 4 speed O/D manual trans. apparently used in the 80's by GM and Chrysler. Is it a good enough trans to warrant swapping one into an auto equipped truck?

I have one from a GM truck and most of the parts required to swap over to a clutch. I was wondering if the manual trans 1/2 ton 2wd used the small or large hump cabs from the factory.

I would appreciate any insight you guys may have. Thanks

Dave

07-31-2003, 01:36 PM	#1
beaterC10 Senior Member Join Date: Jul 2003 Location: Indianapolis, IN Posts: 1,277	Introduction and Question I'm new to the board, joined last week. Thought I should introduce myself. My name is Dave Reasoner. I have a 84 short stepside beater that gets my attention when I have spare time. You guys with kids probably understand 3 kids and a wife take a lot of my time. My question concerns the New Process 833 4 speed O/D manual trans. apparently used in the 80's by GM and Chrysler. Is it a good enough trans to warrant swapping one into an auto equipped truck? I have one from a GM truck and most of the parts required to swap over to a clutch. I was wondering if the manual trans 1/2 ton 2wd used the small or large hump cabs from the factory. I would appreciate any insight you guys may have. Thanks Dave

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.