Blazer tank in k10

[chevyz69]

Hey y'all I'm new to the site and I figured I'd post a question I have...

I have an 85 k10 that I'm currently building up. I am swapping in a 31 gallon blazer tank for the side tank the truck had, and I'm also swapping the motor to TBI since I had everything laying around to do it. I used an 87 harness to swap into the truck for everything and I deleted the dual tank portion of that harness (learned some things along the way)

The motor is mildly modified, and I have the hard parts to run tuned port injection but I don't have a harness or computer. I am going to be running a tpi fuel pump on my modified TBI engine that's going into the truck so....I was wondering if anyone would know a good place to buy fuel lines so I can make my own or any pre-made lines that I could use? If I could make it to where I could reuse most/all of the lines if I swap to tpi, that would be great. Anyone that has done this or anything like it, or anyone have ideas? Anything would be greatly appreciated!!
Posted via Mobile Device