Where to mount front e-level sensors on '68 dropmembered C10?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

funkytechmonkey · 10-04-2011, 01:18 PM

I found a place to mount the rear... but I have no idea where to mount them on the front.

The biggest issue I am coming across is that my drop member, upper and lower control arms are already powder coated. So I dont want to weld anything to them. I dont mind drilling a hole but welding is not an option. Although I can weld on the frame... its painted.

Here are some pics of the rear. I welded a 16 guage plate inside the frame and mounted the sensor to it.

Now I just need to figure out the front. If you have pics of where you mounted yours i would be GLAD to see them.

10-04-2011, 01:18 PM	#1
funkytechmonkey Registered User Join Date: Jan 2011 Location: Lawrenceville, GA Posts: 1,080	Where to mount front e-level sensors on '68 dropmembered C10?? I found a place to mount the rear... but I have no idea where to mount them on the front. The biggest issue I am coming across is that my drop member, upper and lower control arms are already powder coated. So I dont want to weld anything to them. I dont mind drilling a hole but welding is not an option. Although I can weld on the frame... its painted. Here are some pics of the rear. I welded a 16 guage plate inside the frame and mounted the sensor to it. Now I just need to figure out the front. If you have pics of where you mounted yours i would be GLAD to see them. Attached Images __________________ Never wrenched a day in my life and now... Im doing a frame off restoration on a 1968 C10 with a Porterbuilt Dropmember, Acuair E-Level kit, Boyd Welds Gas tank and mild c-notch. Click here to view my build

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.