Need a pic of under dash clutch linkage - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**ScottH** · 10-14-2011, 10:26 PM

I recently picked up a project 66 swb that needed a few things done to get it moving and driving. One of them is the clutch linkage. I'm pretty sure I have it correctly installed on the engine to the clutch fork, but when I try to push the clutch pedal down it just goes all the way to the floor. I'm thinking that the PO (not the brightest candle) did something incorrectly with it under the dash. If someone could post a pic so I see how it correctly is positioned, I would greatly appreciate it.

Thanks!

Scott

10-14-2011, 10:26 PM	#1
ScottH Senior Member Join Date: Sep 2002 Location: Hampstead, NC Posts: 8,190	Need a pic of under dash clutch linkage I recently picked up a project 66 swb that needed a few things done to get it moving and driving. One of them is the clutch linkage. I'm pretty sure I have it correctly installed on the engine to the clutch fork, but when I try to push the clutch pedal down it just goes all the way to the floor. I'm thinking that the PO (not the brightest candle) did something incorrectly with it under the dash. If someone could post a pic so I see how it correctly is positioned, I would greatly appreciate it. Thanks! Scott __________________ 1963 C10 swb fleetside 1966 GMC G1000 Handi-bus (future project) 1955 Chevy 2 dr. wagon

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.