Another Pressure Switch Question...?

[JNJchev77]

I may be making this a little more complicated than it is...

I am running two comp's, two 3 gal tanks with two ports, each. Also a simple 4-switch manual paddle valve set up. One pressure switch....

My questions is, where would be the best place to put the pressure switch in the system to get correct pressure readings? Should I run it off a "t" in front of one of the tanks?

Here's a pic with a generic illustration ;P of how I'm routing my lines. Compressors are mounted at the rear of the chassis... I "t'd" the compressors together just before the tanks, so that if one fails...