Need help wiring ignition switch-photos - The 1947 - Present Chevrolet & GMC Truck Message Board Network

RaceAGMC · 06-17-2012, 06:56 PM

I am just about finished up doing my 6.0 swap in my 1970 C-10. I am in need of help wiring up the ignition switch. I have attached a picture of the back side of the switch an of the wires I am working with along with their labels. Any help to get it going would be great.

Wires
Pink-IGN Empty
Yellow with black stripe-cranking signal
Orange-battery empty
Pink with black stripe-12V switched
Black-ground

If someone could tell me which wires go where on the switch that would help me a lot.

Posted via Mobile Device
Posted via Mobile Device

06-17-2012, 06:56 PM	#1
RaceAGMC Registered User Join Date: Jul 2007 Location: Charlotte, NC Posts: 350	Need help wiring ignition switch-photos I am just about finished up doing my 6.0 swap in my 1970 C-10. I am in need of help wiring up the ignition switch. I have attached a picture of the back side of the switch an of the wires I am working with along with their labels. Any help to get it going would be great. Wires Pink-IGN Empty Yellow with black stripe-cranking signal Orange-battery empty Pink with black stripe-12V switched Black-ground If someone could tell me which wires go where on the switch that would help me a lot. Posted via Mobile Device Posted via Mobile Device __________________ 70 CST, 6.0/ 4L80E in the works. Custom harness by 68 Short Step

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.