Single-Piece Driveshaft Questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

PrimeredThunder · 10-09-2003, 02:26 PM

First off, I have a 72 SWB truck with trailing-arm suspension and I am contemplating converting it to a single-piece rear driveshaft because mine seems to be a bit bent and I am breaking carrier bearings a bit more often than I should

How long does the single driveshaft need to be? I have a 12-bolt rearend and turbo350 trans. Also, I should add that I am running airbags, and am planning on notching the frame soon. I appreciate any help with this,
Thanks,

Kenny

10-09-2003, 02:26 PM	#1
PrimeredThunder Back from the Dead Join Date: Dec 2001 Location: Salem, Oregon Posts: 522	Single-Piece Driveshaft Questions First off, I have a 72 SWB truck with trailing-arm suspension and I am contemplating converting it to a single-piece rear driveshaft because mine seems to be a bit bent and I am breaking carrier bearings a bit more often than I should How long does the single driveshaft need to be? I have a 12-bolt rearend and turbo350 trans. Also, I should add that I am running airbags, and am planning on notching the frame soon. I appreciate any help with this, Thanks, Kenny __________________ The only Carb that matters to me is the one under my hood! Salem, Oregon

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.