6.0 swap

[Bhelton]

Ok here is another thread by me!

Just completed disk brake swap and have decided to to a engine swap to a 06' 6.0. I am looking for parts to make this easy and less work. So here is what's needed if someone could point me in the right inexpensive way I'd appreciate it greatly!!

Harness and ECM will go to Jim's performance unless there is someone else on the board that can do that part.

I want to run my 400 tranny since I just put $800 in to it....so is there anyone who builds torque converters to go from 1st gen tranny to 3rd gen engine?

Motor mounts....open to all suggestions

Fuel pump and regulator.... Open to all suggestions

A/C I won't to upgrade system and use the compressor off of the 06' model, I was thinking old air made a kit to do that?

Electric fan...again want to get the best bang for the buck

Power steering...I would like to tie the new pump into my current box
Posted via Mobile Device