How to properly install '63-64 rear axle wheel seals? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Reyals Bemus · 03-12-2013, 11:11 PM

Can anyone share some insight on the proper way to install these not-so-common rear axle seals found on '63-64 C10s?

These are fully encased in rubber, unlike the more common '65-up types which have the actual inner rubber seal bonded to the otherwise steel frame. I had actually tried to install the later type in my '64 housing but the later seal was actually too big (approx. .050").

So do I just lube these seals up with a little oil and push em flush into the housing?

03-12-2013, 11:11 PM	#1
Reyals Bemus Registered User Join Date: Dec 2007 Location: Billerica, MA Posts: 329	How to properly install '63-64 rear axle wheel seals? Can anyone share some insight on the proper way to install these not-so-common rear axle seals found on '63-64 C10s? These are fully encased in rubber, unlike the more common '65-up types which have the actual inner rubber seal bonded to the otherwise steel frame. I had actually tried to install the later type in my '64 housing but the later seal was actually too big (approx. .050"). So do I just lube these seals up with a little oil and push em flush into the housing?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.