|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-22-2013, 04:24 PM
|
#1 |
|
Registered User
Join Date: May 2005
Location: michigan
Posts: 9
|
Control arm shaft centering tolerances
So i installed new bushings and shafts in my upper control arms and as far as the shafts being centered, one control arm was off .070" and the other was .072" off center. what i did was indicate each shaft hole and used an edge finder and bumped up to the side of the arm. Is this something to be concerned about? I really dont want to take these apart again.
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode