|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-28-2013, 01:57 AM
|
#1 |
|
Registered User
 
Join Date: Oct 2006
Location: San Jose NOR*CAL
Posts: 3,080
|
250 clifford valve cover question
I got a finned valve cover,and a finned air cleaner and installed them.
But I have a question about the PCV hook up. The old valve cover had 3 holes the new one has one, plus a breather "box" on the right rear of it. The old valve cover had two breathers on it and a pcv valve on the side going to the the bottom of the air cleaner. My question is were can I put the pcv valve on the new valve cover and were should I hook it up? I was thinking of a pcv oil filler cap with the pcv hose hooked up to the intake ( a clifford manifold ) Or do I hae to drill the valve cover ? Is the intake port a good place to attach the pcv? Or is the air cleaner hook up ok ?
__________________
1960 Apache long bed fleet L6 250 Clifford intake 2 bbl carb. Langdon cast headers with dual exhaust and bellflower tips. T-5 5 speed, power steering and power disc brakes. "Over, Around or through it... " |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode