Is this ball joint installed right?

[softballnrd27]

85 C10 CPP 2.5" drop spindles, 2" drop springs, poly bushings.
So I thought I had an issue with the control arm bc the ball joint was going in and out of the hole. So I bought a control arm new moog ball joint and bushings to fix the problem. The ball joint went in the control arm like it should same with the bushings. I got everything installed and was putting the ball joint through the spindle and it didn't seem to go in the hole far enough. It just didn't look right, but I can put the cotter pin through the ball joint with the nut on, but it just doesn't look right.
Pic:

Posted via Mobile Device