I've got another question about parts swapping

[kieth]

If you go the donor route you can use the transmission crossmember from the donor, but I did not like the way it looked (not symetrical) from a 91 burb, so we bought a trans crossmember that was tubular. here are some pictures.

here is a picture of a 91 burb 700r4 crossmember.....ugly
http://kieth.smugmug.com/Trucks/66-G...5117&k=PgmxqZ5


here is a aftermarket crossmember cannot remember where we got it.

http://kieth.smugmug.com/Trucks/66-G...5CwP&lb=1&s=X3


We thought this looked better and made more room available between the frame rails.

Kieth


here is what we used from a 91 burb, that cost $700.00:
engine, trans, serpentine belt system, tbi, ps pump, psgearbox, complete front crossmember w/discbrakes and sway bar, wiring harness, buse box, tilt wheel, etc.......cheap and functional....