Pre-LS swap questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Angryman117 · 11-08-2013, 12:20 AM

The 700R4 and 4L60E are very similar but the cross member on the 60 sits back about an inch or so than the 700. I know this cause I did what you were talking about doing. Thankfully the mounts I have are bolt in and not welded. I was also thinking about getting my drive shaft sized with the 700, good thing I didn't. I got a 99 4L60E from a suburban with the torque converter from a local salvage yard for about $300. How far are you from Hitterdal, MN? I got my engine from there, found on CL for about $550 with everything I need to make the engine run. I am sure they would have a couple of 60's laying around.

11-08-2013, 12:20 AM	#10
Angryman117 Registered User Join Date: Jul 2013 Location: VAFB, CA Posts: 227	Re: Pre-LS swap questions The 700R4 and 4L60E are very similar but the cross member on the 60 sits back about an inch or so than the 700. I know this cause I did what you were talking about doing. Thankfully the mounts I have are bolt in and not welded. I was also thinking about getting my drive shaft sized with the 700, good thing I didn't. I got a 99 4L60E from a suburban with the torque converter from a local salvage yard for about $300. How far are you from Hitterdal, MN? I got my engine from there, found on CL for about $550 with everything I need to make the engine run. I am sure they would have a couple of 60's laying around. __________________ Angryman117's 47 Chevy Build 89 Silverado Z71 LS Swap (sold)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.