scott's or porter built? air ride or coil over?

[PBFAB.COM]

Originally Posted by Dilemmaofny

Hey guys. Has anyone installed the porterbuilt kit? I have a 68 c10. I wanna do a body drop. I see porterbuilt has a kit. I was looking into getting the stage 3 kit. I spoke to someone from porterbuilt. He said I would have to raise the engine and tranny about 3 inches. Is this something I would have to fabricate or is it when I install the kit and place the engine and tranny back in,it will raise the engine and tranny 3 inches?

We do offer motor mounts, and to add a little clarification, the Dropmember you are referring to lowers the truck in the crossmember by approx 3 inches. This does move the drivetrain up, but it's just over 1 1/2 inches not 3. Clearances do begin to get tight at the trans tunnel. We recommend installing a large hump trans tunnel to gain the extra clearance needed. Once you do a body drop you will lose another 3/4 inches.... The cab floor will need some additional mods at that point.

Nate