Vent Window latch question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

BWickstrom · 07-02-2014, 05:02 PM

I bought a new vent latch because the one I had kept coming off. I installed the new one and it came off too. When it did I lost the Roll Pin. When I close the vent there is a fair amount of pressure on it, maybe too much due to old seals, etc.

I saw there was a thread about them in FAQ http://67-72chevytrucks.com/vboard/s...d.php?t=603510

But there wasn't an answer to my question, is there anything you guys have done, or modified, to keep the Roll Pin in place?

07-02-2014, 05:02 PM	#1
BWickstrom Registered User Join Date: Mar 2014 Location: Stuart, FL Posts: 20	Vent Window latch question I bought a new vent latch because the one I had kept coming off. I installed the new one and it came off too. When it did I lost the Roll Pin. When I close the vent there is a fair amount of pressure on it, maybe too much due to old seals, etc. I saw there was a thread about them in FAQ http://67-72chevytrucks.com/vboard/s...d.php?t=603510 But there wasn't an answer to my question, is there anything you guys have done, or modified, to keep the Roll Pin in place?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.