|
07-18-2014, 02:28 PM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: Woolwich Twp, NJ
Posts: 445
|
Porpotioning Valve
ok... so I've done a bit of reading. Disk / Drum setup... 3/16 lines to the front from front reservoir - 1/4 lines to the rear block and then 3/16 to each drum. Ok... I was provided a McGaughy's proportioning valve for the rear and I understand that's to keep the rear from locking up - but the input and output on the valve itself are 3/16 so now I'm wondering if I go down to 3/16 to go through the valve why am I not running 3/16 all the way back at that point? Am I making sense here?
__________________
64 Step Side - The Mistress |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode