|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-23-2014, 10:13 PM
|
#1 |
|
Registered User
Join Date: May 2014
Location: SAN FRANCISCO
Posts: 447
|
Driveshaft mounting question
Since my truck didn't come with a motor, trans or driveshaft I've got a few questions.
I've installed a SM465, measured the driveshaft length and gave the dims to the shop. They had a good donor driveshaft the right length with a slip joint and are installing new u-joints and balancing it tomorrow. My question is concerning the hardware. He says he has the U-bolts but I seem to remember a couple of blots threaded in to the back of the trans... does the rear end and or the trans use U-bolts or the I'll call them U-brackets (the flat U's) that would bolt on with conventional bolts. Oh, and if someone can confirm that both ends use 1310 u-joints that would help too. The shop determined they were from the measurements I provided but... Thanks,
__________________
'66 C10 SWB '64 C2 roadster '38 Indian Scout Flattracker '70 Triumph T120R '81 Laverda Jota Last edited by scuderia; 07-23-2014 at 10:52 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode