Porterbuilt Dropmember - The 1947 - Present Chevrolet & GMC Truck Message Board Network

nibs · 09-07-2014, 11:37 AM

Hey fellow members... Need some more insight!

I have an Extreme with an LS swap. I just got the engine in and I am looking to get the steering linkage done. Does anyone have any pics of how they did it with an LS? Im confident that its going to be done with a 3 joint setup.

Thanks!

FYI! My pan(not F-body LS1) does fit. I did shim the rack out with 2 washers, with no interference with the notch. It is tight, could maybe use 1 more washer. Here are the pics

09-07-2014, 11:37 AM	#11
nibs JRods Garage Join Date: Dec 2009 Location: East Highland, CA Posts: 1,098	Re: Porterbuilt Dropmember Hey fellow members... Need some more insight! I have an Extreme with an LS swap. I just got the engine in and I am looking to get the steering linkage done. Does anyone have any pics of how they did it with an LS? Im confident that its going to be done with a 3 joint setup. Thanks! FYI! My pan(not F-body LS1) does fit. I did shim the rack out with 2 washers, with no interference with the notch. It is tight, could maybe use 1 more washer. Here are the pics __________________ Orange Julius-My dropmember'd, LS'd, SWB street machine...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.