|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-12-2014, 11:16 PM
|
#1 |
|
Registered User
Join Date: Feb 2012
Location: Elyria, ohio
Posts: 180
|
triangulated 4 link installed
I was originally going to do a parallel 4 link but decided to do a triangulated so I didn't have to mess with a watts link or panhard. I Built a cross member with a tunnel for the drive shaft out of 3/16" wall square tubing and wwelded it inside the frame rails and reinforced it with additional tubing on top of the frame rails.
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode