Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
12-30-2013, 02:29 PM | #1 |
Registered User
Join Date: Nov 2011
Location: Lyman, SC
Posts: 734
|
Porterbuilt Stage 1 Front and Rear Kit Chart
When I was looking for info on Porterbuilt's Stage 1 kits, I found very few before and after pictures for comparison purposes. So when I decided to go this route, I figured that I would take some pictures of my truck in the same place, from the same angle before and after installing the Stage 1 kits.
Once I got to this point, I decided I wanted to go lower, so I added McGaughy's 2.5" drop spindles. Then I wanted to go lower in the rear, so I added Porterbuilt's 2 piece bolt in notch. I took pictures of the truck aired up and aired out after every change so that others could see what results come from various combination of parts. Now that I have my truck where I want it, I put together the chart below with some of the pictures. FYI - Since adding the notch, I basically have the Stage 2 rear kit in the bottom two pictures. Some measurements from the ground to the top of the wheel arch in the fender: Stock: 32"/33" (front/rear) Stage 1 Up - 33"/34" Stage 1 Down - 26"/27" W/ drop spindles Up - 30"/34" W/ Drop Spindles Down - 24"/27" W/ Notch up - 30"/32" W/ Notch Down - 24"/25" Hopefully someone finds this helpful. Here's a link to the full size version: https://dl.dropboxusercontent.com/u/...%27s%20C10.pdf Of course this wouldn't have been possible without the help of Travis at Pro Performance!
__________________
Matt Criswell - Lyman, SC 1972 Chevy Cheyenne SWB - Build: Porterbuilt State 1 Front & Rear, Bolt in Notch, McGaughys 2.5 Drop Spindles, Boyd Welding Fuel Tank UPSTATE SC GM TRUCK CLUB: FACEBOOK WEBSITE |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|