Small block where there was a 6 (1966) - The 1947 - Present Chevrolet & GMC Truck Message Board Network

HSRACER · 08-13-2015, 02:42 PM

So far the only problem I have run into is the clutch pivot ball on the 72 engine I am putting in the 66 has a ball that is on a bracket that positions it way to far back. I have been told that the correct ball location is to find one that just bolts directly to the forward hole the my current bracket is bolted to. Then everything else should work.

Does this sound right to everyone?

Thanks for any help or guidance as to where I can find one of these pivot balls.

08-13-2015, 02:42 PM	#1
HSRACER Registered User Join Date: Sep 2007 Location: Katy TX Posts: 1,268	Small block where there was a 6 (1966) So far the only problem I have run into is the clutch pivot ball on the 72 engine I am putting in the 66 has a ball that is on a bracket that positions it way to far back. I have been told that the correct ball location is to find one that just bolts directly to the forward hole the my current bracket is bolted to. Then everything else should work. Does this sound right to everyone? Thanks for any help or guidance as to where I can find one of these pivot balls. __________________ HSRACER Slammed 53 5 window Blown/Bagged 54 Pickup Patinaed 67 LS stepside Supercharged 67 Nova Bagged 69 Suburban Turbo'ed 5.3 LS

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.