New guy here with a 65 GMC 3/4 ton

[65 GMC]

Been awhile since I posted any progress. So far I have the front cross member swap complete. I installed a sweet mfg u-joint in the steering column as I wanted to use the collapsible shaft from the 1978 donor truck. The u-joint was rather pricey but it's better than trying to dodge a 3/4 steel shaft in an accident. I got my drop spindles, 4" rear lowering springs and rear axle install kit from POL. Now I just need to swing the truck around and start on the rear end. Going to pull the trailing arm set up from the 66 Chevy donor today, and hopefully get the rear end out of the GMC also. Here are some photos to show the progress.