Help with Rear Patch Panel Fleetside 66

[msg]

Originally Posted by MP&C

Your weld dots don't look bad at all, how are they on the back side?

Heres a shot of the back side of the panel. Not great, but hopefully good enough.



Since there are more areas that needed to get repaired I havent yet painted the repairs yet, I figured patch as much as possible and then mix up the epoxy primer. So I tried to repair spots in the top portion of the rear of the panel that were eaten up with rust. The attempt I made to just cut a spot out failed when I couldnt get behind that area well to planish. So I cut out the whole stretch and hope that I can take left over scrap thats long enough and cut to fit.






So while Im cleaning out that area the best I can and neutralize the rust with Ospho, I moved on to try repairing some holes from a repair someone else had done as well as plug the lower blinker hole that someone added.





I have been using the tack planish grind and sand method and I hope to get it going smoother. Took me about 8 hours to get this much done today