|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-18-2016, 01:23 AM
|
#2 |
|
Registered User
Join Date: Sep 2008
Location: San Carlos, Ca.
Posts: 3,048
|
Re: How to install engine dipstick tube
IIRC, on the small blocks that I had, there was a "pinched ring" on the dipstick which also worked as a stop. I would work a small drift around that ring just tapping my way around until it seated. It was somewhat of an interference fit. I would use a light skim of RTV to avoid any leakage.
__________________
Chris '63 k15 long step Vortec 7.4 - L29 Blackbear tune, Five 0 Motorsports injectors, Chris Straub Cam, NV4500, divorced 205  52" front and 63" rear spring swap D44 / 14bff - disc axles Milemarker 9K and 10.5K hydraulic winches 63" & B52 Spring Install http://67-72chevytrucks.com/vboard/s...ng+swap+thread NV4500 Reverse Build Thread http://67-72chevytrucks.com/vboard/s...=reverse+build L29 - 7.4 Vortec Build http://67-72chevytrucks.com/vboard/s...&highlight=L29 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode