1946 3/4 ton ful floater - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**dennislbrooks** · 04-28-2016, 08:17 AM

I am getting ready to drop the oem full floater to fit up a truck 12 bolt ---- will be 6 lug all way around with the 57 front axle. I am not sure yet if the 46 FF is a 4.56 or 5.17. Does anyone know of a use for this full floater --- I take if used in another vehicle it would need fitted with disc and I doubt if there is a locker for it.

Other than junk value does anyone have a use for the oem front axle or rear diff?

And does anyone know the ujoint size --open driveshaft -- for the front of the 46 3/4 ton?

04-28-2016, 08:17 AM	#1
dennislbrooks Senior Member Join Date: Feb 2004 Location: Williamsburg, Ohio Posts: 1,801	1946 3/4 ton ful floater I am getting ready to drop the oem full floater to fit up a truck 12 bolt ---- will be 6 lug all way around with the 57 front axle. I am not sure yet if the 46 FF is a 4.56 or 5.17. Does anyone know of a use for this full floater --- I take if used in another vehicle it would need fitted with disc and I doubt if there is a locker for it. Other than junk value does anyone have a use for the oem front axle or rear diff? And does anyone know the ujoint size --open driveshaft -- for the front of the 46 3/4 ton? __________________ 1942 Chevy 1/2 ton Rod, 1959 GMC 1/2 ton Fleet Stepside, 1967 Chevy SWB K10, 1985 Corvette Coupe 4+3, 2015 Chevy Duramax reg cab 4WD W/T

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.