6.0 Swap w/new Enytropy Radiator/Fans running hot when not moving. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Nodnarb76 · 06-09-2016, 11:47 AM

Still fixing all the little problems after doing my 6.0/4L80 Swap into my 87 Suburban. Along with the motor installed an Enytropy radiator/fan kit.
Fans come on low speed then high speed like they are supposed to.
When I'm driving and have airflow through the radiator, everything is fine, once I come up to a light or stop, temp goes up about 20-30 degrees, even if the fan is on high speed, then goes back down when I start moving. When I installed the motor I replaced the water pump and thermostat with new AC Declo parts.
Any ideas?

06-09-2016, 11:47 AM	#1
Nodnarb76 Registered User Join Date: May 2013 Location: Mississippi Posts: 501	6.0 Swap w/new Enytropy Radiator/Fans running hot when not moving. Still fixing all the little problems after doing my 6.0/4L80 Swap into my 87 Suburban. Along with the motor installed an Enytropy radiator/fan kit. Fans come on low speed then high speed like they are supposed to. When I'm driving and have airflow through the radiator, everything is fine, once I come up to a light or stop, temp goes up about 20-30 degrees, even if the fan is on high speed, then goes back down when I start moving. When I installed the motor I replaced the water pump and thermostat with new AC Declo parts. Any ideas? __________________ 1987 R20 Suburban LQ4/4L80e swap: http://67-72chevytrucks.com/vboard/s...d.php?t=693824

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.