Just Ordered My Parts - The 1947 - Present Chevrolet & GMC Truck Message Board Network

8t5Silverado · 03-13-2004, 12:34 PM

Western Chassis 2.5 spindles, 1.5 coils, and a rear hanger since I already have some new shackles.

I am going to order some Doetch Techs and get some balljoints this weekend.

I chickened out on the flip kit. I am afraid it will be too low since my springs are sagging in the rear about 1 to 1.5 inches. I didn't want the front to sit higher than the rear, and if it doesn't look right, I can always change it back and do a flip kit later.

Now I am pondering whether or not I should get the Prothane poly bushing kit from Summit and do it all at once, since it will be apart.

03-13-2004, 12:34 PM	#3
8t5Silverado Mudslides 'r my specialty Join Date: Dec 2003 Location: STL Posts: 1,106	Western Chassis 2.5 spindles, 1.5 coils, and a rear hanger since I already have some new shackles. I am going to order some Doetch Techs and get some balljoints this weekend. I chickened out on the flip kit. I am afraid it will be too low since my springs are sagging in the rear about 1 to 1.5 inches. I didn't want the front to sit higher than the rear, and if it doesn't look right, I can always change it back and do a flip kit later. Now I am pondering whether or not I should get the Prothane poly bushing kit from Summit and do it all at once, since it will be apart. __________________ Always on the lookout for old cars and parts...(20s, 30s, 40s, 50s, 60s, etc.) http://www.cardomain.com/memberpage/500339

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.