94 pickup parts for sale

[Joey-T]

94 pickup parts for sale
The following parts are located in Fairmount, Indiana, zip 46928. They are being removed from a 94 GMC 1500, 2 wheel drive. I must sell ASAP to keep the bank from taking the house! I can't hold anything, so whoever has money gets the parts...

These items MUST be picked up, or I can deliver within 75 miles for a fee...

99% rust free long bed. This is a nice bed as far as rust problems go, but there are small dents and such to work out. The most obvious is the front stake pockets. It looks like someone cranked in a "pocket loop" and caused them to crush a little. The bedsides are pretty much straight, but I used this truck, so small dents and scratches are there. This is a nice, above-average bed for your project. Bed only, tailgate sold seperate. $350

98% rust free tailgate. There is some small bubbles forming on the underside lip. Not much, really, and if you get after it now, you're golden. There are some small dents. The trim around the handle will need replaced. Very solid. $75

99% rust free cab. Still has cab corners! This is cab only, interior, glass and doors are not included. The only downside is that there is no title. There are a couple dents where a buddy who was helping me dinged the cab with the bed when we were putting the bed back on. Windshield is there, but cracked. Ask any questions you need. $350

REPRO hood. Hood was put on, but never painted. There is some surface rust in the corners, but no rust through. There are a few small dents. Very solid. $50

REPRO driver side fender. This one was never installed! The underside was jammed out in dark blue, and has been kept indoors. NO RUST! $40

Radiator core support. I'm not sure, but I assume this is a repro. There is some slight surface rust, but it is solid and not beat up. $40

PAIR of door shells. I'm selling these together, and CHEAP, because they are not perfect. These are gutted shells only- no interior, no glass, no inner webbing. They have a small amount of surface rust forming on the underside-bottoms, but you can get at them now before rust sets in. There are some dents- one side has a bit more than the other, but both are very workable. $40

Rear glass- solid type (not a slider). Has dark aftermarket tint. $25

Driver door glass- glass is good, guides (whatever they are called) needs replaced. Has dark aftermarket tint. $20

Driveshaft- came from a V8 with 4L60E tranny (longbed, remember). $20

SUSPENSION- I can do this two ways- you can buy a rolling frame complete with suspension for $200, or you can buy the rearend and springs for $100, the entire front suspension for $75 and the frame for $50. Save money by buying the whole rolling frame!

I do have a few other items, most of which I'd be willing to ship. If I have time, I'll advertise them in a seperate post later, or you can post here or email me to inquire. I have a few tan interior items left, a few underhood items and I still have part of the AC system (which blew COLD!).

Also, I have a bench seat from an 88- red in color, but needs new upholstery. $25

I DO NOT have the engine, tranny, gas tank or any of the wiring. Don't have bumpers either.