|
testing lq4: no oil at rockers
I have a 6.0 lq4 that i bought off craigslist a while back. I swapped the cam, replaced heads, new springs, oil pump, timing chain, push rods (7.4" TSP)
the bottom end is still stock and i inspected it for any damage or wear. looked good.
during final assembly i put 5 its into the motor through the top end and then rolled the motor over to see if i got any oil out of the push rods and into the rocker. NONE that i can see. What could be causing this issue? I just used the starter without plugs or coil packs while on the engine stand in order to check.
|
11-19-2016, 01:36 AM
Threaded Mode