NP205 question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

eighteenninetytwo · 12-13-2016, 01:23 PM

Giving the truck a once over now its out of shop, before starting on the interior.
put it into 4WD to get the front driveline and diff moving again. I noticed that there was adefined move into 4WD (Hi) at the back of the travel but when it went back to 2WD there a) was less of a defined shift and b) the front driveline was still moving as a drove (hoel in floor i look through) not much but a bit. Is this related to it not being in 4WD for a couple of years and it needs to loosen up properly or it is just messed up?

12-13-2016, 01:23 PM	#1
eighteenninetytwo Registered User Join Date: Sep 2013 Location: Redwood city, CA Posts: 694	NP205 question Giving the truck a once over now its out of shop, before starting on the interior. put it into 4WD to get the front driveline and diff moving again. I noticed that there was adefined move into 4WD (Hi) at the back of the travel but when it went back to 2WD there a) was less of a defined shift and b) the front driveline was still moving as a drove (hoel in floor i look through) not much but a bit. Is this related to it not being in 4WD for a couple of years and it needs to loosen up properly or it is just messed up?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.