02-12-2017, 01:23 PM | #1 |
Registered User
Join Date: Aug 2015
Location: Kaufman, TX
Posts: 15
|
Drive shaft question.
I have a 1972 GMC 3/4 ton that had a 402 with a Muncie 4 speed with granny gear. I swapped it out for an 5.3 LS with a 4l60e. The truck has a two piece drive shaft. The original 4-speed had a bolt on yoke. The 4l60e has a slip yoke. Is it okay to use a slip yoke on a two piece driveshaft? It already has a slip joint between the carrier bearing and the rear end. The carrier bearing is mouned in rubber. Will that allow too much movement? Anyone have experience with this issue?
Thanks |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|