Brake Residual Valve Location Help

[NeoJuice]

I think I got a little to excited that I was finally starting to get my brake lines run. I've run into a little problem with plumbing my front brakes.

I did the rear correctly as in the first mbmbrakes picture with a single line run to the back with one 2lb residual valve.

Then I got a little to excited and ran one line to each front wheel to the wilwood combination valve. It's a little more brake line but I figured I would use the two "front out" ports on the wilwood because I didnt have a plug. The origional plan was only to run one line to the front then "tee" off for the passenger side.

I havent plumbed the master cylinder yet to the wilwood so I'm ok there.

Now the question is.....Can I plumb in the 2lb residual valve just off the master cylinder before the wilwood? or does it have to be after as shown in the second mbmbrake image i modified? if so then I will need to go buy another valve and re-cut/flare them in somewhere.

Any help would be appriciated. Pictures are attached.