Pictures of my rear end - The 1947 - Present Chevrolet & GMC Truck Message Board Network

MiraclePieCo · 02-14-2018, 05:18 PM

Okay, I'm not going Harvey Weinstein on you, I just need help identifying this pinion yoke so I can get u-joints and make a driveshaft. It's a GM 12-bolt but the pinion yoke seems non-standard. Those cups are 1-1/16" but that's supposed to be an outside clip u-joint but there are no retaining tabs. My local driveline guy suspects someone ground off the retaining tabs. I'm much more familiar with Ford rear ends; any classic Chevy guys help me out?

02-14-2018, 05:18 PM	#1
MiraclePieCo Registered User Join Date: Sep 2014 Location: USA Posts: 2,249	Pictures of my rear end Okay, I'm not going Harvey Weinstein on you, I just need help identifying this pinion yoke so I can get u-joints and make a driveshaft. It's a GM 12-bolt but the pinion yoke seems non-standard. Those cups are 1-1/16" but that's supposed to be an outside clip u-joint but there are no retaining tabs. My local driveline guy suspects someone ground off the retaining tabs. I'm much more familiar with Ford rear ends; any classic Chevy guys help me out? Attached Images Last edited by MiraclePieCo; 02-15-2018 at 04:26 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.