|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-08-2018, 01:00 PM
|
#2 |
|
Senior Member
   
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,491
|
Re: horse-shoe small block engine mounts / oil pan
I had to drop the pan after I put the engine back in because I used the wrong pan seal. I was able to do it easily though. My truck is a 63, so I'm not sure if there is much difference between the cross members.
I did not remove the starter. All I had to do was drop the exhaust and rotate the engine to where the counterweight of the crank was up in the block at the front of the engine
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode