|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-08-2018, 04:45 PM
|
#1 |
|
Almost Satisfied
 
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,932
|
LS Crank Pulley Install
I'm at my wits end. I need to reinstall my pulley, but it won't slip on far enough for the original bolt threads to catch. I've tapped it lightly, but don't want to brute force it on their for obvious reasons. I don't have a torch to heat it. I rented the kit at O'Reilly's. It doesn't reach. I really don't want to spend $60 for a tool I will use once.
I went to fastenal to make my own. They only have 3' of all thread. By the time you buy all the pieces it gets too expensive to make that approach work. Any other ideas? Anyone have the LS tool laying around? It shouldn't be this hard LOL
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far." |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode